Oxygen Thermal Gas Flow Meter

Position :Home> Products >Flow Meter >Thermal Mass Flow Meter > Oxygen Thermal Gas Flow Meter

philemoninstrument@gmail.com
+0086-371-26665538

Principle

Thermal gas mass flow meter is designed on the basis of thermal dispersion, and adopts method of constant differential temperature to measuring gas flow. It has advantages of small size, easy installation, high reliability and high accuracy, etc.

The meter contains two platinum resistance temperature sensors. The thermal principle operates by monitoring the cooling effect of a gas stream as it passes over a heated sensor. Gas flowing through the sensing section passes over two sensors one of which is used conventionally as a temperature sensor, whilst the other is used as a heater. The temperature sensor monitors the actal process values whilst the heater is maintained at a constant differential temperature above this by varying the power consumed by the sensor. The greater the gas velocity, the greater the cooling effect and power required to maintain the differential temperature. The measured heater power is therefore a measure of the gas mass flow rate.

Feature

♦ Measuring the mass flow or volume flow of gas
♦ Do not need to do temperature and pressure compensation in principle with accurate measurement and easy operation.
♦ Wide range: 0.5Nm/s~100Nm/s for gas. The meter also can be used for gas leak detection
♦ Good vibration resistance and long service life. No moving parts and pressure sensor in transducer, no vibration influence on the measurement accuracy.
♦ Easy installation and maintenance. If the conditions on site are permissible, the meter can achieve a hot-tapped installation and maintenance. (Special order of custom-made)
♦ Digital design, high accuracy and stability
♦ Configuring with RS485 or HART interface to realize factory automation and integration

Philemon Instrument Co, LTD. | Philemon CMS

certificate

Philemon Instrument Co, LTD. | Philemon CMS

Structure	Insertion	Pipe
Medium	Gas (except acetylene)
Pipe Range	DN100-DN4000	DN10-DN2000
Velocity	0.1~120 Nm/s
Accuracy	±1%	±2.5%
Working Temperature	-40℃～+220℃
Transmitter	-20℃～+45℃
Working Pressure	≤2.5 MPa	≤4.0 MPa
	Medium pressure≤ 1.6MPa
Remote type	Compact type: 24VDC or 220VAC, Power consumption ≤18W Remote type: 220VAC, Power consumption ≤19W
Response	1s
Signal Output	4-20mA (optoelectronic isolation, maximum load 500Ω), Pulse, RS485 (optoelectronic isolation) and HART
Alarm	1-2 line Relay, Normally Open state, 10A/220V/AC or 5A/30V/DC
Pipe Material	Carbon Steel, Stainless Steel
Protection Grade	IP65
Sensor Material	Stainless steel Carbon Steel, Stainless Steel
Display	4 lines LCD Mass flow, Volume flow in standard condition, Flow totalizer, Date and Time, Working time, and Velocity, etc

Inquiry

If you have any suggestions or opinions about our products,please leave a message,and we will immediately answer your questions. Thanks for your support.E-mail:philemoninstrument@gmail.com Tel:+0086-371-26665538

Previous Article:Female Threaded Turbine Flow Meter

Next Article:Flow Meter for Low Flow